AA-BOND 2115 Laser Manufacturing High Impact Optically Clear Epoxy Adhesive

$19.95
SKU:
AA-BOND 2115-1
Availability:
Ships within 24 hours
Technical Product Bulletin

Laser Manufacturing High Impact Clear Epoxy

PRODUCT DESCRIPTION:

AA-Bond 2115 is low viscosity epoxy formulation used in the fabrication of lasers. AA-Bond 2115 is an optical clear epoxy where alignment accuracy is essential. AA-Bond 2115 withstands 30 seconds of 60 watt direct laser energy. This adhesive has been used in cycling applications.

AA-Bond 2115 bond has good resistance to water and weathering, most petroleum solvents, mild acids and alkalis and other chemicals.

 

GENERAL PROPERTIES:

Technology

Epoxy

Color

Clear

Cure

Room temperature cure or Heat cure

Operating temperature

-50 to 105 °C

Product Benefits

Low viscosity

Low shrinkage

Good mechanical shock resistance

Excellent temperature cycling

performance

Mix Ratio, by weight-

Resin : Hardener

100 : 30

Application

Manufacturing and Assembly

Typical Optic Application

Laser fabrication and Other optic applications

Substrates

Glass, Rigid plastics, Ceramic and Metals

 

 

TYPICAL PROPERTIES OF UNCURED MATERIAL

Viscosity @ 25 °C, cP:

After Mixing 260 10

Specific Gravity, mixed 1.19

Pot Life, hours 1.5

 

TYPICAL CURING PERFORMANCE

 

Cure Schedule

25°C

24 hours

60°C

1 to 2 hours

 

 

PHYSICAL PROPERTIES:

Coefficient of Thermal Expansion, cm/cm/ºC

5.50×10-05

Glass Transition Temperature (Tg), °C

55

Shore D

77

Izod Impact Strength, ft-lb/in. of notch

0.22

 

 

ELECTRICAL PROPERTIES:

 

Dielectric Strength, volts/mil

430

Dielectric Constant @ 25ºC : 1kHz

4.8

Dissipation Factor @ 25ºC : 1kHz

0.01

 

TYPICAL PERFORMANCE OF CURED MATERIAL

Lap Shear Strength, psi:

Substrate

Aluminum to Aluminum

3700

 

GENERAL INFORMATION

For safe handling information on this product, consult the

Safety Data Sheet, (SDS).

DIRECTIONS FOR USE

1. Carefully clean and dry all surfaces to be bonded

2. Burst the pouch and thoroughly mix the AA-BOND 2115 epoxy adhesive system components in the handy plastic pouch until color is uniform throughout.

3. Apply this completely mixed adhesive to the prepared surfaces, and gently press these surfaces together. Contact pressure is adequate for strong, reliable bonds; however, maintain contact until adhesive is completely cured.

4. Some ingredients in this formulation provided in the plastic pouch, and bulk packaging may crystallize when subjected to low temperature storage. A gentle warming cycle of 50ºC for 30 minutes prior to mixing components may be necessary. Crystallized epoxy components do not react as well as liquid components and should be redissolved prior to use for best results.

 

Data Sheets: TDS | MSDS available upon request.

Atom Adhesives
Typically replies within an hour

Atom Adhesives
Hi there 👋

How can I help you?
1:40
×
Chat with Us