Technical Data Sheet
PURE SILVER FILLED ELECTRICALLY CONDUCTIVE EPOXY, LONG POT LIFE ADHESIVE
PRODUCT DESCRIPTION
AA-DUCT 902LP is an epoxy adhesive and coating formulation based on pure silver. This versatile silver formulation offers the maximum continuity of conductivity with an electrical resistivity value of less than 1x10-4 ohm-cm.
AA-DUCT 902LP is also characterized by a wide operating temperature range from -50 to +170°C.
AA-DUCT 902LP is recommended for electronic bonding and sealing applications that require both fine electrical and mechanical properties.
PRODUCT PROPERTIES
Appearance | Silver |
Cure Type | Heat cure or Room temperature |
Benefits |
|
Mix Ratio by weight | 100:6 Resin to Hardener |
Operating Temperature | -50°C (-58°F) to +170°C (338°F) |
Substrates | Excellent choice for aluminum, copper, magnesium, steel, bronze, nickel, kovar, ceramic, glass, phenolic, and G-10 epoxy glass boards |
Typical Applications | Electrical, conductive, EMI/RFI shielding, circuitry, printed circuit board, and electronics repair |
UNCURED PROPERTIES
Viscosity @ 25 °C, cps | Paste |
Specific Gravity, mixed | 2.79 |
Reactive solids contents, % | 100 |
Pot Life | 3 hours |
Shelf Life | 1 year |
CURE SCHEDULE
20 minutes | 120°C (248°F) |
50 minutes | 100°C (212°F) |
24 hours | 25°C (77°F) |
CURED PROPERTIES
Hardness, Shore D | 85 |
Shrinkage, linear in/in | 0.003 |
Tensile Strength, psi | 9500 |
Volume Resistivity, ohm·cm | < 0.0001 |
Compressive Strength, psi | 14,000 |
Lap Shear Strength, psi | 9400 |
THERMAL PROPERTIES
Thermal Conductivity, btu/hr/ft²/°F/in | 100 |
Thermal Expansion Coefficient, cm/cm/°C × 10⁻⁵ | 1.5 |
Heat Distortion, °C | 95 |
GENERAL INFORMATION
For safe handling information on this product, consult the Safety Data Sheet, (SDS).
HOW TO USE
- Carefully clean and dry all surfaces to be bonded.
- Apply AA-DUCT 902LP completely mixed adhesive to the prepared surfaces, and gently press these surfaces together. Contact pressure is adequate for strong, reliable bonds; however, maintain contact until adhesive is completely cured.
- Some separation of components is common during shipping and storage. For this reason, it is recommended that the contents of the shipping container be thoroughly mixed prior to use.
- Some ingredients in this formulation provided may crystallize when subjected to low temperature storage. A gentle warming cycle of 52°C for 30 minutes prior to mixing components may be necessary. Crystallized epoxy components do not react as well as liquid components and should be re-dissolved prior to use for best results.
AVAILABILITY
This epoxy can be supplied in various different packages.
Data Sheets: TDS | MSDS available upon request.