| PRODUCT DESCRIPTION: AA-BOND F110 is an optically clear adhesive with a very low viscosity. AA-BOND F110 is room temperature system an excellent choice for thin bond-line assembly and repair applications of prisms, lenses and other optic components. And its high strength makes this epoxy ideal for structural applications. AA-BOND F110 exhibits excellent wetting and wicking capabilities which allows it to adhere strongly to glass, ceramics, metals and most rigid plastics. PRODUCT PROPERTIES: | Color | Part A (Resin): Clear Part B (Hardener): Clear to light yellow | | Cure Type | Room Temperature or Heat cure | | Benefits | · High strength · Good insulation properties · Good resistance to salt solutions, mild acids and Alkalis and many other chemicals | | Mix Ratio by weight | 100:11 Resin to Hardener | | Substrates | Excellent choice for thin bond-line assembly and repair applications of prisms, lenses and other optic components | | Operating Temperature | -40°C (-40°F) to +130°C (266°F) | | Substrates | Most metals, Ceramics, Glass and Etc. | | Typical Applications | Electrical casting and encapsulating, circuitry, electronic component casting and etc. | UNCURED PROPERTIES: | Mixed Viscosity @ 25 °C cps | 310 ±50 | | Specific Gravity gm/cc | Mixed: 1.16 | | Reactive solids contents, % | 100 | | Pot Life | 30 minutes | | CURE SCHEDULE: | 24 hours | At 25°C (77°F) | | 1-2 hours | At 65°C (149°F) | CURED PROPERTIES: | Hardness, Shore D | 84 | | Volume Resistivity ohm. cm | 6.0 E+13 | | Lap Shear Strength alum to alum, PSI | 2150 (24 hrs @ 25°C) 2600 ( 1 hr @ 65°C) 3000( 4 hrs @ 65°C) | | Dielectric strength, volts/mil | 410 | | Coefficient of Thermal Expansion | 90 X10-6 in/in/°C | OPTICAL PROPERTIES: | Refractive Index | 1.54 | | Transmission, Visible | 97% | GENERAL INFORMATION: For safe handling information on this product, consult the Safety Data Sheet, (SDS).
HOW TO USE: - Carefully clean and dry all surfaces to be bonded.
- Apply AA-BOND F110 completely mixed adhesive to the prepared surfaces, and gently press these surfaces together. Contact pressure is adequate for strong, reliable bonds; however, maintain contact until adhesive is completely cured.
- Some separation of components is common during shipping and storage. For this reason, it is recommended that the contents of the shipping container be thoroughly mixed prior to use.
- Allow the product to cure according to the cure schedule.
AVAILABILITY: This epoxy can be supplied in many different packages. |
