AA-COAT WD 1 Wood Coating Low Viscosity Capillary Action Sealer Epoxy Finest Encapsulation

$99.99 - $199.99
SKU:
AA-COAT WD1

Technical Product Bulletin

Wood Coating Lowest Viscosity Capillary Action Sealer


 

PRODUCT DESCRIPTION:

 

AA- COAT WD1 is an optically Clear, low viscosity, high impact epoxy adhesives specially developed for sealing wood bamboo, hard boards & forestry products.  This product allows for capillary action to encapsulate providing the finest finish for hard to coat wood grain, cracks, and holes.  This product contains no VOC’s with deepest surface penetration.

 

AA- COAT WD1 is a two part coating easily mixed and cured at room temperature or accelerated by heat. It offers a good pot life and improve impact strength.  

 

GENERAL PROPERTIES:

Appearance

Clear

Cure Type

Room temperature  or Heat cure

Benefits

·         Wood Coating

·         Low viscosity

·         Long working time (Pot life)

Mix Ratio by weight

100:30 / Resin: Hardener  

Typical Application

Most Metals , Wood , Polyester, Glass, Glass fabrics, Hard boards & forestry products, Ceramics, Countertops and other materials

Operating Temperature

-40  to  135 °C

 

UNCURED PROPERTIES:

Specific Gravity, mixed

0.98

Reactive solids contents, %

100

Pot Life at 25 °C  100 grams

2.5 hours

Shelf life

1year @ 25 °C 

Viscosity, cps  at 25 °C 

210

 

 

 

 

CURED PROPERTIES:

Hardness, Shore D

78

Tensile Strength,   Psi

7400

Dissipation Factor,  60Hz

0.010

Volume Resistivity,  ohm/cm

3.3x 1015

 

CURE SCHEDULE:

Full cure at Room  temperature   25°C

48-72 hours

110 °C ( 230 °F)

1/2 to 1 hour 

Dry to touch 

14 hours

 

 

GENERAL INFORMATION:

For safe handling information on this product, consult the Safety Data Sheet (SDS).

HOW TO USE:

 

1.       Carefully clean and dry all surfaces to be coated or bonded.

 

2.       Mix by hand stirring or with mechanical agitation until catalyst and resin are uniformly dispersed.  Mix ratio must be observed by either weight or volume.  Incorrect mix ratio will yield inconsistent results.

 

3.       Vacuum may be used where required for absolute bubble-free coating.

 

 

Storage:

 

AA-COAT WD1 should be stored at RT temperature with ventilated area. 

 

AVAILABILITY:

    This epoxy can be supplied in many various packages.

Data Sheets: TDS | MSDS available upon request.

Atom Adhesives
Typically replies within an hour

Atom Adhesives
Hi there 👋

How can I help you?
1:40
×
Chat with Us